Service manual

MAINTENANCE PROCEDURES : TILT EOT SENSOR REPLACEMENT

02.9678.0010 G 45

Tilt EOT Sensor Replacement

VL Part No: 23.9661.1253

Repair/Replacement Procedure

Step 1. Disconnect luminaire AC input cable from power source.

Step 2. At tilt-side leg, remove yoke leg cover by removing four 6-32x3/8" PTB screws.

Step 3. At sensor bracket, remove two 10-32x1/2" PPZ screws and remove bracket.

Step 4. Disconnect wiring from Tilt Encoder PCB.

Step 5. At sensor, remove two 6-32x3/8" PPZ screws and remove sensor from bracket.

Step 6. Replace by performing steps 2 through 5 in reverse order.

Figure 2-25: VL3000 Tilt EOT Sensor Replacement

Tilt Motor

Head not shown for clarity.

NOTE:

Assembly

Spring

Sensor

Bracket

Tilt Belt