User`s manual

TROUBLESHOOTING AND MAINTENANCE

02.9676.0019 A 05-January-2004 69

Note: In some cases it is easier to slide bulkhead partially out of head assembly to access color filters.

To do this, use #2 Phillips screwdriver to turn captive screw one-quarter turn and slide bulkhead

upward. Disconnect motor connections as necessary.

Step 3. Remove CYM Color / Dimmer Assembly.

Step 4. Rotate wheel until required color filter is accessible at finger access cutout.

Figure A-3: Filter Access

CAUTION: Do not touch color filters with bare fingers. Wear cotton gloves or other covering while

replacing. Clean with glass cleaner and soft cloth if required.

Step 5. Using fingers, pull color filter out of wheel.

Step 6. Noting proper orientation of carrier indention,

insert new color filter into position and push

fully into place.

Step 7. Re-install bulkheads and re-install removable

cover.

Figure A-4: Color Filter Removal

Finger Access

Cutout

Color Filter

Color

Filter Wheel

Color Filter

Carrier Indention