User`s manual

TROUBLESHOOTING AND MAINTENANCE

02.9676.0019 A 05-January-2004 67

CAUTION: Wear cotton gloves or other covering while servicing lamp. Touching lamp glass with

bare fingers will leave oil and may cause the lamp to explode or reduce lamp life. If required, use

alcohol and cotton cloth to thoroughly clean glass portion of lamp.

Step 4. Remove lamp by pulling straight out of socket.

Step 5. Install new lamp by pressing into socket. Ensure lamp is fully seated in socket and parallel

to guide rods. (Lamp can be damaged when inserted through reflector if not parallel to

guide rods.)

Step 6. Align guide rods in guide holes and slide backcap into head assembly. Re-tighten captive

knob.

Step 7. If required, reset lamp hour counter as follows. (Refer to “Menu System” chapter on page 49

for more information.)

a. Power up luminaire.

b. At Menu Display, press [Menu].

c. Press [Up] / [Down] arrows until Config (Configuration) appears. Press [Enter].

d. Press [Up] / [Down] arrows until LAMP appears. Press [Enter].

e. Press [Up] / [Down] arrows to access ResetHrs (Reset Lamp Hours). Press [Enter] to

reset lamp hour counter.

Step 8. Align lamp. Refer to “Align Lamp for Flat Field” on page 19.