User`s manual

OPERATION : LUMINAIRE TIMING
3
02.9676.0019 A 05-January-2004 43
Control Channel Functions
The following control actions must be accomplished with zero time transition or with timing disabled.
Discrete values must be used and not manual controls such as faders or encoders.
To use control channel functions:
Step 1. Select an action to be sent.
Step 2. Set control channel value for desired action (for example, 84 for reset). Hold value for 3
seconds.
Note: A numerical keypad is required for sending values. An encoder or fader does not allow for a
“snap” value change, which is required to affect the control functions.
Step 3. Set control channel value to zero. (This must occur without any scaling values. Action will
be voided if other values are detected between action value and zero.)
98 250 300
251 310
99 252 310
253 310
254 310
100 255 Follows Cue Data
Table 3-15: Control Channel Functions
Control
Channel
Function
Control Channel Value
% Value DMX Value
After
3 Secs
Display On 1 1-4 0
Luminaire Reset 33 81 - 87 0
Lamp Off 66 165 - 171 0
Lamp On 99 249 - 255 0
Table 3-14: Timing Channels Map (Continued)
% Value DMX = Seconds