User`s manual

VARI❋LITE® - VL2500™ SPOT LUMINAIRE USER’S MANUAL
20 05-January-2004 02.9676.0019 A
Addressing
Program Starting Address
The address setting for DMX console controlled systems is entered using the Menu Display (refer to
“Menu Operation” on page 50). The luminaire retains the DMX address even if power is removed.
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
Program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to scroll to starting address.
Step 4. Press [Enter] to set.
Program Starting Address Without Calibrating
Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.
Program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu].
• When display changes from "Starting" to the DMX address, program address as in Program
Starting Address above.
Note: The luminaire will require a reset to restore control.