Service manual

VARI❋LITE® - VL2500™ SPOT LUMINAIRE SERVICE MANUAL
34 29-May-2009 02.9676.0020 B
Enclosure Assembly
This section provides removal and replacement procedures for components found in
the luminaire enclosure assembly.
Removing Enclosure Covers
To gain access to enclosure components, it will be necessary to remove the top and
bottom covers.
To remove and replace enclosure covers:
Step 1. Using console or internal menus, run lens as far to the rear as possible.
Step 2. Disconnect luminaire AC input cable from power source.
Step 3. At each top enclosure cover, remove two 6-32×1/4" PPB screws and remove
cover as shown in Figure 2-19.
Figure 2-19: Removing Top and Bottom Enclosure Covers
6-32×1/4" PPB Screw
Power Supply
Ballast-Side Cover
1/4-20×1/2" Socket Screw
1/4" Split Lock Washer
Side Cover
Ventilation
Cover