Service manual

MAINTENANCE : MAINTENANCE PROCEDURES
2
02.9676.0020 B 29-May-2009 33
Ignitor PCB Replacement (continued)
Step 8. Remove two 1/4" hex standoffs from ignitor PCB by removing one 6-32×5/
16" PPZ screw and #6 lock washer. Install in same place on new ignitor
PCB. Figure 2-18.
Figure 2-18: Ignitor PCB Standoff Removal
Step 9. Install replacement assembly by performing Steps 2 through 8 in reverse
order.
1/4" Hex 6-32
.500" LG Standoff (2)
6-32×5/16"
PPZ Screw
#6 Lock Washer