Service manual

MAINTENANCE : MAINTENANCE PROCEDURES
2
02.9676.0020 B 29-May-2009 27
Edge Motor Assembly Replacement (continued)
Step 6. At side rail, disconnect edge motor wire connector from junction connector.
Figure 2-11.
Figure 2-11: Disconnecting Edge Motor Wiring
Step 7. Remove two 4-40×3/8" PPZ screws and nuts which secure motor to bulkhead
and remove motor assembly. Figure 2-12.
Figure 2-12: Edge Motor Assembly Replacement
Step 8. Install replacement assembly by performing Steps 2 through 7 in reverse
order.
Junction Connector
1/4" Nuts
Edge Motor
Assembly
4-40×3/8"
PPZ Screws