Service manual

MAINTENANCE : MAINTENANCE PROCEDURES

02.9676.0020 B 29-May-2009 25

Edge Motor Assembly Replacement

Parts:

21.9667.0310

To remove and replace edge motor assembly:

Step 1. Disconnect luminaire AC input cable from power source.

Step 2. Remove front assembly. Refer to “Front Assembly Removal” on page 21.

Step 3. Cut cable ties that secure edge motor wires to front assembly. (Edge motor is

larger of two linear actuator motors.)

Step 4. The rotating gobo wheel obscures one of the screws securing the edge motor

assembly to the front assembly. At rotating gobo wheel, turn gobo wheel

until the open frame is over head of obscured screw. Figure 2-9.

Figure 2-9: Accessing Edge Motor Assembly Attaching Hardware

Rotating Gobo Wheel

Front Assembly

(Shown exploded for clarity.)

Open Frame

of Gobo Wheel

Obscured Screw