Service manual

VARI❋LITE® - VL2500™ SPOT LUMINAIRE SERVICE MANUAL
22 29-May-2009 02.9676.0020 B
Front Assembly Removal (continued)
Step 7. At junction connector, disconnect edge motor and zoom motor wires.
Step 8. Face head nose upward. At front of bulkhead, using #2 Phillips long handle
screwdriver, remove four 6-32 X 3/8" PPZ screws (note, tether will be
attached to one screw), and pull front assembly partially out of head
assembly.
Step 9. At rear of bulkhead, disconnect wires from rotating gobo sensor PCB.
Figure 2-7.
Step 10. Re-install front assembly by performing Steps 2 through 6 in reverse order.
While re-installing, first connect wiring harness connection to rotating gobo
wheel sensor and route wires through corner between head assembly and
bulkhead (ensuring no wires are pinched).