Service manual

MAINTENANCE : MAINTENANCE PROCEDURES
2
02.9676.0020 B 29-May-2009 21
Front Assembly Removal
Parts:
22.9676.0016
Note: This procedure may be necessary to gain access to other components.
To remove and re-install front assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At luminaire, remove both top and bottom covers as follows:
a. Loosen two captive screws and remove top cover as shown in Figure 2-6
(the cover is attached by tether).
b. At bottom cover, loosen three 8-32 x 1/2" PPB screws and remove cover.
Step 3. Remove front nose cover by removing two 10-32×1/2" PPB screws (one on
each side).
Step 4. Remove CYM crossfade color assembly.
Step 5. Remove Color/Gobo/Iris Assembly.
Step 6. At front assembly, disconnect wire connectors from rotating gobo index
motor and rotating gobo wheel motor.
Figure 2-6: Front Assembly Removal
Captive Screws
Route wiring harness here
Removable Cover
Front Nose Cover
Screw (2)
Junction Connector
Wire Connector