Service manual
MAINTENANCE : MAINTENANCE PROCEDURES
2
02.9676.0020 B 29-May-2009 19
Standard Gobo/Color Filter Replacement
WARNING: Users of VARI❋LITE® luminaires should not install or use metal gobos. The
use of metal gobos in any VARI
❋LITE® product may damage the luminaire and could void
the luminaire’s warranty.
Parts:
Standard Gobo or Color Filter as required
To remove and replace a standard gobo or color filter:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At top head cover, loosen two captive screws and remove cover as shown in
Figure 2-3 (it will remain attached by tether).
Note: In some cases it is easier to slide bulkhead partially out of head assembly to
access gobos/filters. To do this, use #2 Phillips screwdriver to two 6-32 PPZ screws
and slide bulkhead upward. Figure 2-4.
Step 3. Remove CYM crossfade color assembly.
Step 4. Rotate wheel until required gobo/filter is accessible.
CAUTION: Do not touch filters with bare fingers. Wear cotton gloves or other
covering while replacing.
Step 5. Using fingers, pull gobo/filter out of wheel. Figure 2-4.
Step 6. Noting proper orientation of carrier slot, insert new gobo/filter into position
and push fully into place.
Step 7. Re-install bulkhead (if applicable) and re-install head cover.
Figure 2-4: Standard Gobo/Color Filter Replacement
Gobo/Color
Filter Wheel
Gobo/Color Filter
Carrier Slot