Service manual

MAINTENANCE : TROUBLESHOOTING
2
02.9676.0020 B 29-May-2009 13
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the
Menu Display will cycle through any applicable error message(s), one at a time until the end
of the list is reached. To review the error messages again, it will be necessary to access them
using the Status function. (Refer to
“Troubleshooting Guide” on page 14 for a list of
possible causes and remedies associated with the error messages.)
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Fixture appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access Status. Press [Enter]. (Display will now
scroll through any error messages or display OK if no errors.)
WARNING: As with any repairs or maintenance to Vari-Lite luminaires, service should
only be performed by a trained and qualified service technician or at an Authorized Vari-Lite
Service facility.
Table 2-1: Error Messages
Display Message...
OK No Errors Found
Pan/No Sens Pan sensor not found.
Pan/Encoder/Fail Pan encoder failure.
Tilt/No Sens Tilt sensor not found.
Tilt/Encoder/Fail Tilt encoder failure.
Index/No Sens Gobo Index sensor not found.
Gobo/No Sens Rotating Gobo sensor not found.
Fixed Gobo/No Sens Fixed Gobo sensor not found.
Dimmer/No Sens Dimmer sensor not found.
Blue/No Sens Blue sensor not found.
Amber/No Sens Amber sensor not found.
Magenta/No Sens Magenta sensor not found.
ColWheel/No Sens Color wheel sensor not found.
Zoom/No Sens Zoom sensor not found.
Edge/No Sens Edge sensor not found.