User`s manual

MENU SYSTEM : OPERATION
4
02.9673.0001 D 02-May-03 59
MODE DMX Mode Accesses functions for setting DMX mode to standard or enhanced 8-bit or
16-bit.
Modl Model Displays model number of luminaire. For example, 2413 (VL2413).
Move Move Enables and disables pan and tilt movement and auto-correction.
MSEQ Master Sequence A sequence playback mode which will replay the cues from the master
luminaire.
NoPg No Program Indicates that there is no software present in the luminaire.
OFF Off Turns off a function.
OK Okay Indicates that luminaire is ready to accept commands.
OK? Okay? Prompt for pressing [Enter] before an action is executed.
ON On Indefinitely Sets Menu Display to stay on until programmed otherwise (DisP), turns on
a function, or turns on a menu item.
P UP Lamp Power Up Accesses options for lamp power up: on, off, or after calibration.
P/T Pan/Tilt Accesses pan and tilt options for DMX function, system configuration, and
testing.
Pan Pan Specifies pan function for manual control (Man) or pan encoder for testing
(Test).
PASS Test Pass Indicates that sensor test has passed.
PCue Play Cue Accesses cue list for play back of cues by number.
POWR Lamp Power Accesses function to turn lamp on or off.
PSEQ Play Sequence Plays back cue sequence. Press [Enter] to start and [Menu] to stop.
RDef Reset Default Resets default system configuration values.
RGob Rotating Gobo Tests rotating gobo wheel.
RHrs Reset Lamp Info Resets lamp hour and lamp strike counters. For use when new lamp is
installed.
RTST Run-Test Indicates that a system mechanism test is in progress.
Sens Sensors Accesses sensor choices for diagnostic testing.
SEQ Sequence Play-
back
Sets sequence playback mode to Individual (plays cues from each lumi-
naire) or Master (all luminaires play same cue).
STAT Status/Error Dis-
play
Allows scrolling through error list or displays OK if no errors.
Stor Store Cue Stores cue by number. Cue number stored is dependent on next cue ID in
cue list since this field is not editable.
Str Strobe Specifies strobe function for manual control.
Strk Strike Displays total number of lamp strikes.
STST Sensor Test Indicates that a system sensor test is in progress.
SWAP Swap Swaps pan and tilt functions for special focus requirements such as moving
mirror mechanisms.
Test System Tests Accesses diagnostic tests for internal mechanisms.
Table 4-2: Menu Fuction Definitions (Continued)
Display Definition Purpose