User`s manual

VARI❋LITE - VL1100CD ERS LUMINAIRE USER’S MANUAL
24 15 February 2011 02.9665.0001 0
Addressing
Program Starting Address
The DMX starting address is entered using the Menu Display. This address will be retained even if the
power is removed.
Note: Refer to Chapter 4: Menu System for detailed instructions on menu functions.
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
To program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. DMX will appear. Press [Enter].
Step 4. Press [Up] / [Down] arrows to enter starting address.
Step 5. Press [Enter] to set.
Program Starting Address Without Calibrating
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.
To program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in Program Starting
Address above.
• Release when display reads ":"
Note: The luminaire will require a reset to restore control.