User`s manual

INSTALLATION : POWERING UP

02.9665.0001 0 15 February 2011 21

Standard Power Up Procedure

Use this procedure when powering up a luminaire that has already been configured. (Refer to “Power-

Up and Configuration Overview” on page 20.)

Note: Refer to Chapter 4: Menu System for detailed instructions on menu functions.

CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head and

yoke can move freely without restriction.

To power up luminaire:

Step 1. At each luminaire, apply power by switching on power source. Luminaire will display

Starting for 10-15 seconds, and then automatically step through the following procedure:

1) If Lamp Power-Up State is set to Lamp On, lamp will strike (ignite).

2) Luminaire will cycle through calibration and stop at "home" position.

3) If Lamp Power-Up State is set to Cal On, lamp will strike (ignite) at end of

calibration sequence.

4) If Lamp Power-Up State is set to Lamp Off, them Luminaire will cycle through

calibration and stop at "home" position. Lamp will not strike (ignite) until a Lamp

On command is received by luminaire.