User`s manual

VARI❋LITE® - VL1000™ ERS LUMINAIRE USER’S MANUAL
56 25-Feb-02 02.9663.0001
Fixture Fixture Access luminaire specification information such as model, serial number,
software version, along with status information.
Frame 1A -
Frame 4B
Frame Side Specifies shutter frames 1A, 1B, 2A, 2B, 3A, 3B, 4A or 4B for manual
control depending on which one is selected at the Manual Commands
menu.
GoboIndx Gobo Index Specifies gobo index EOT sensor for testing.
Incand Incandescent Specifies luminaire as having an incandescent lamp source.
Index Gobo Index Specifies rotating gobo index for manual control.
Inv Pan Invert Pan Reverses pan action for special focus requirements.
Inv Tilt Invert Tilt Reverses tilt action for special focus requirements.
Lamp Lamp Accesses lamp power up options and information (Config).
Lamp OFF Lamp is Off Configures arc luminaire so that lamp will not strike upon power up.
Lamp ON Lamp is On Configures arc luminaire so that lamp will strike upon power up.
LampHour Lamp Hours Displays total number of lamp operating hours.
LampType Lamp Type Accesses menu item for configuring luminaire for arc or incandescent
source.
Lum Id Luminaire ID Displays unique luminaire ID number.
Magenta Magenta Specifies manual control of Magenta (Manual) or test Magenta functions
(Test).
Manual Manual
Commands
Accesses functions for controlling luminaire mechanisms and timing by
entry of an absolute data value.
Model Model Displays model number of luminaire. For example, VL1000TS.
Movement Movement Enables and disables pan and tilt movement and auto-correction.
No No Specifies that the luminaire does not contain the shutter accessory.
OFF Off Turns off a function.
OK Okay Calibration has completed and no errors have occurred.
OK? Okay? Prompt for pressing [Enter] before an action is executed.
ON On Indefinitely Sets Menu Display to stay on until programmed otherwise (Display) or
turns on a function.
Pan Pan Specifies pan function for manual control (Manual) or pan encoder for
testing (Test).
Pan/Tilt Pan/Tilt Accesses pan and tilt options for DMX function, system configuration,
and testing.
PASS Test Pass Indicates that sensor test has passed.
Power Lamp Power Accesses function to turn lamp on or off.
PROG Programming Currently programming the new version of software.
Re-Cal Recalibrate Recalibrates luminaire.
Re-Cal Recalibrate Currently executing Calibration.
ResetDef Reset Default Resets default system configuration values.
ResetHrs Reset Lamp Info Resets lamp hour and lamp strike counters. For use when new lamp is
installed.
Table 4-3: Menu Function Definitions (Continued)
Display Definition Purpose