User`s manual

MENU SYSTEM : MENU OPERATION
4
02.9663.0001 25-Feb-02 51
Menu Default State
The menu display’s default state during normal operation is to display the address.
After 10 seconds of inactivity at the display, it will change to this default state.
After 5 minutes of inactivity, the menu display will switch to its off state.
Menu Shortcuts
A few button combinations are provided as shortcuts for frequently used menu
functions. These are as follows:
• Lamp On - Press and hold [Up], then press [Enter]. (Arc models only.)
• Lamp Off - Press and hold [Down], then press [Enter]. (Arc models only.)
• Recalibrate - Press and hold [Up], then press [Menu].
• Interrupt Calibration - Press [Menu] at Power up. (See “Program Starting Address
Without Calibrating” on page 27 for more information.)
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence
the Menu Display will cycle through any applicable error message(s), one at a time
until the end of the list is reached. To review the error messages again, it will be
necessary to access them using the Status function. (Refer to “Troubleshooting” on
page 62 for a list of possible causes and remedies associated with the error messages.)
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Fixture appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access Status. Press [Enter]. (Display will
now scroll through any error messages or display OK if no errors.)
Table 4-1: Error Messages
Display Message...
OK No Errors Found
Pan/No Sens Pan sensor not found.
Pan/Encoder/Fail Pan encoder failure.
Tilt/No Sens Tilt sensor not found.
Tilt/Encoder/Fail Tilt encoder failure.
Index/No Sens Gobo Index sensor not found.
Rot Gobo/No Sens Rotating Gobo sensor not found.
Lamp/Strike/Fail Lamp strike failure.