User`s manual

MENU SYSTEM : CUES AND SEQUENCES

02.9673.0001 C 17-Sep-02 67

Cue Operations

The following section provides instructions for performing cue, sequence, and

playback operations.

Note: The Mod, Del, PCue, PSEQ commands will all display "---" if no cues

have been stored.

Note: After 10 seconds of inactivity at the display, it will change to the default state

showing the address.

To use the menus:

The data stored by the luminaire is “last takes precedence.” This means the last

command received by the luminaire will be the basis of the cue to be stored.

To clear all input data and timing values from previous tests or cues, cycle power to

the luminaire with DMX data cables disconnected. This will reset parameter’s data

and timing values to defaults.

Set position:

Step 1. Press [Menu].

Step 2. Press [Up]/ [Down] arrows until Man appears. Press [Enter].

Step 3. Press [Up]/ [Down] arrows until desired parameter appears. Press [Enter].

Step 4. Press [Up] / [Down] arrows to adjust value. (The values wrap from 0 to 255

in either direction. Pan and Tilt values operate in a range of 0-4095, and wrap

also.) Press [Enter] to set value.

Step 5. Parameter timing can be set using the Time sub-functions. This allows

timing to be added to Intensity, Pan & Tilt, Color, and Beam parameters.

Set follow time between cues:

The following procedure is used to set the follow time between each cue. The value

can be different for each cue. The range is 0.0 to 365.9 seconds.

Step 1. Press [Menu].

Step 2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].

Step 3. Press [Up] / [Down] arrows until FLTM appears. Press [Enter].

Step 4. Press [Up] / [Down] arrows to set value. Once the value is set press [Enter]

button. The display will return to FLTM.