User`s manual

INSTALLATION : ADDRESSING
2
02.9673.0001 C 17-Sep-02 23
Addressing
Program Starting Address
The address setting for DMX console or Virtuoso console controlled systems is
entered using the Menu Display. (Refer to “Menu System” chapter on page 51 for
detailed instructions.)
The luminaire retains the DMX and Virtuoso addresses that are stored even if power is
removed.
Note: Refer to your console operating instructions for specific information regarding
its addressing requirements.
Program a DMX or Virtuoso starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until ADDR (Address) appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to access DMX (DMX console control) or VIRT
(Virtuoso console control). Press [Enter].
Step 4. Press [Up] / [Down] arrows to enter starting address.
Step 5. Press [Enter] to set.
Program Starting Address Without Calibrating
the Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display
programming in order to pre-program an address setting.
Program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in
Program Starting Address above.
Note: The luminaire will require a reset to restore control.