User`s manual

INSTALLATION : INSTALLATION PROCEDURES

02.9673.0001 C 17-Sep-02 15

Installation Procedures

Installing Lamp

In the event the lamp was packed separately during shipment, it will be necessary to

install in the luminaire before use.

WARNING: Ensure that power is removed from luminaire when installing lamp.

CAUTION: Wear cotton gloves or other covering while installing lamp. Touching

lamp glass with bare fingers will leave oil and may cause the lamp to explode or

reduce lamp life. If touched, use alcohol and cotton cloth to thoroughly clean glass

portion of lamp.

To install lamp:

Step 1. Ensure power is removed from luminaire.

Step 2. Remove lamp from shipping box.

Step 3. At backcap, using slotted screwdriver (or

fingers) turn captive knob until loose.

Step 4. Slide backcap away from head assembly (it will

remain attached by tether and lamp wires.).

Step 5. Install lamp by pressing into socket. Ensure lamp is fully seated in socket

and parallel to guide rods. (Lamp can be damaged when inserted through

reflector if not parallel to guide rods.)

Step 6. Align guide rods in guide holes and slide backcap into head assembly. Re-

tighten captive knob.

Note: After installing a new lamp, it is necessary to adjust the beam for optimum

performance. This procedure is covered in “Powering Up” on page 20.

Captive Knob

Backcap Assembly

Guide Rod

Lamp

CAUTION:

Ensure lamp is seated

straight in socket before

re-installing backcap.