User`s manual

MANUAL CONTROL : KEYPAD CONTROL
4
02.9651.0001 C 23-Sep-02 69
Setting Parameters From Keypad
Intensity
The keypad can be used to adjust the brightness of the luminaire’s beam. Intensity
responds to a percentage value of 0-100.
The [At] button is used to enter intensity values:
• <Chan> [n] [At] [m] [Enter] - changes the intensity level of the selected channel to
m.
• <Chan> [n] [Thru] [q] [At] [m] [Enter] - changes the intensity level for the
selected range of channels to m.
The [Full] button is used to quickly set intensity to 100%.
• <Chan> [n] [Full] [Enter] - changes the intensity level of the selected channel to
100%.
The [+] and [-] buttons can be used in combination with the [At] button to increment
or decrement a current intensity value by a specific amount. For example, if the
current intensity value is 50%:
• <Chan> [n] [At] [+] [0] [5] [Enter] - increases the intensity level of the selected
channel to 55%.
• <Chan> [n] [At] [-] [0] [5] [Enter] - decreases the intensity level of the selected
channel to 45%.
To quickly enter an intensity below full, but divisible by 10, use only the first digit of
the desired level (for example, [At] [5] = 50%).
Presets
The keypad can be used to assign presets to selected luminaires. The preset entered on
the keypad corresponds to the preset saved in that particular preset select (refer to
“Presets” on page 93).
Examples:
• <Chan> [n] [Preset] [m] [Enter] - applies preset m to the selected channel n (where
m is the discrete preset number).
• <Chan> [n] [Thru] [q] [Preset] [m] [Enter] - applies preset m to the selected range
of channels (where m is the discrete preset number).
Colors
The keypad can be used to assign colors to selected luminaires. The color entered on
the keypad corresponds to the color saved in that particular color select (refer to
“Colors” on page 89).
Shortcut