User`s manual

VARI❋LITE® - VIRTUOSO™ / VIRTUOSO™ DX CONSOLE USER’S MANUAL
62 23-Sep-02 02.9651.0001 C
Image (Gobo)
Images can be controlled by the soft encoders when [Image] is selected. These knobs
can be used to access the gobo, effects, and prism features of a luminaire.
The soft encoders will be mapped as follows:
Encoder 1 - GOBO (open/other)
w/ [Shift] button pressed - WHEEL SPIN (max/stop)
Encoder 2 - ROTATING GOBO (open/other)
w/ [Shift] button pressed - ROTATING SPIN (max/stop)
Encoder 3 - INDEX (open/other)
w/ [Shift] button pressed - ROTATE (max/stop)
Encoder 4 - EFFECTS WHEEL (open/other)
w/ [Shift] button pressed - EFFECTS SPIN (max/stop)
Encoder 5 - EFFECTS INDEX (open/other)
w/ [Shift] button pressed - EFFECTS ROTATE (max/stop)
Encoder 6 - EDGE (hard/soft)
w/ [Shift] button pressed - ZOOM (large/small)
3D
3D parameters can be controlled by the soft encoders when [3d] is selected. These
knobs can be used to adjust X, Y, and Z coordinates of the luminaire.
The soft encoders will be mapped as follows:
Encoder 1 - X (min/max)
Encoder 2 - Y (min/max)
Encoder 3 - Z (min/max)
Dynamic States
Dynamic states can be controlled by the soft encoders when [Dyn] is selected. These
knobs can then be used to adjust the parameters of dynamic states as defined by the
Dynamic State feature available on the touch screen display.
Note: This is an advanced feature and will be discussed in “Dynamic State Mode” on
page 163.
The soft encoders will be mapped as follows:
Encoder 1- ORIENT (min/max)
Encoder 2 - SIZE (min/max)
Encoder 3 - RATE (min/max)