User`s manual

VARI❋LITE® - VIRTUOSO™ / VIRTUOSO™ DX CONSOLE USER’S MANUAL
38 16-Apr-02 02.9651.0001B
Note: The next three steps are only required if you intend to use the console’s 3D
graphic features. For more information regarding these coordinates, refer to “Defining
X, Y, Z Locations” on page 274.
f. Use default 3D X, Y, and Z coordinates or enter new ones.
g. Use Position pop-up menu to specify luminaire orientation and location
(i.e. hanging, floor mount, stage left, etc.).
h. Use pointer or Rotate arrows to rotate luminaire to required position.
i. When finished, click Save.
Step 4. Repeat Steps 1-3 for each DMX luminaire in your system.
Step 5. When all luminaires are defined in your patch, at Patch menu, select
Disable Editing. (This prompts a dialog allowing you to save editing.)
Specify lamp control
source preheat level
Position luminaire
Define 3D settings
or use defaults
Conventional Patch Window
Click “Add Scroller” to
highlight Scroller window
Define channel range
Select Profile
Thumbwheel Address -
Can be any number from
1-2000 as long as it does not
conflict with an existing address
Channel Assignment -
Channel which will control fixture
Bus Choice
(see next page)
Click “Add Scroller” to
highlight Scroller window
(see next page)