User`s manual

TIMING/FILTER DISPLAYS : DYNAMIC STATE MODE
9
02.9651.0001 C 23-Sep-02 165
With dynamic state running, at soft encoder display, select [Dyn]. The soft encoders
will be mapped as follows:
Encoder 1- ORIENT (min/max)
Encoder 2 - SIZE (min/max)
Encoder 3 - RATE (min/max)
Using encoder knobs and min/max buttons, adjust parameters as required.
Storing Dynamic States as Cues/Presets
Dynamic states can be applied to luminaires or groups of luminaires and stored as a
cue or preset.
Storing guidelines:
• When stored into a cue/preset, the state information, as well as the established size,
speed and axis (controlled from the encoders) are stored.
• When stored into a cue/preset, the parameters affected by the dynamic state will
follow the timing information for those parameters before assuming any dynamic
state speed information.
• A dynamic state must be running in order to be stored as a cue/preset.
Note: Luminaires incapable of an action will ignore the command. For example, a
luminaire without a color wheel would not respond to a “Spin Color Wheels” state.
Store a dynamic state:
Step 1. Select required channel(s).
Step 2. At screen/window, select desired state. Luminaires will assume dynamic
action.
Step 3. At soft encoder display, select [Dyn]. Adjust applicable encoders and min/
max buttons to set axis, size, and speed.
Step 4. Store cue or preset as usual.