User`s manual

TIMING/FILTER DISPLAYS : FILTER MODE

02.9651.0001 C 23-Sep-02 161

Filter Mode Operation

When the Filter mode is accessed, by default, all parameters are selected (not filtered).

Change filtering for parameters as follows:

• To prohibit the store or recall of all attributes of a parameter, use the button located

just below the screen to deselect all.

• To prohibit the store or recall of one attribute of a parameter (zoom, for example),

select the appropriate cell on the screen to deselect.

The parameter grids at the screen, command-line display, and submaster displays

indicate the filtered (or non-filtered) state of each parameter. The Filter

button must be pressed before the command-line or submasters grids will reflect the

filter settings.

• When none of a parameter’s (I, F, E, C, B, G) attributes are filtered, its box is

highlighted.

• When some of a parameter’s attributes are filtered, the box is gray.

• When all of a parameter’s attributes are filtered, its box is clear.

• After adjusting the filter settings, the filters can be applied to preset or cue store

and playback functions.

Applying Filters To Cues

The Filter button is used to apply filters to a cue store operation.

Using filters while storing cues:

Step 1. Set filters as required.

Step 2. Press filter . The filter state will be applied to all cues stored from

this point on, until changed.

Step 3. Store cue as usual (refer to “Storing” on page 119).

To Cue

store cue 1

Store Cue 1 Label ∗

Start

No attributes filtered

All attributes filtered

Some attributes filtered

To Cue