User`s manual

BASIC EFFECTS : CREATING EFFECTS

02.9651.0001 C 23-Sep-02 147

From Effects Window

Use sets and sequences to create an effect:

Step 1. At Data menu, select Effects. Effects window will

open.

Step 2. Using cursor, enter sequence and set information for

each effect.

Note: One pre-programmed set is available, which contains all patched channels as a

single part. To use Set 0, enter 0 as the set number.

Step 3. Using keyboard, label as required.

Defines Set

Assigns effect to autoload

into a specific submaster

Defines Sequence

Direction, Mode, Cycle, and Start attributes

Timing Information

(covered in Advanced

Effects chapter)

Sets Random time (covered in Advanced Effects chapter)