User`s manual

VARI❋LITE® - VIRTUOSO™ / VIRTUOSO™ DX CONSOLE USER’S MANUAL
144 23-Sep-02 02.9651.0001 C
Creating Effects
Effects can be created using the command-line keypad, Effects Control panel, or
Effects window.
When creating effects, the current settings for the Direction, Mode, and Start buttons
will be stored upon a store operation. (For creating basic effects, you can use the
default direction, mode, and start selections.)
The default timing settings can also be used. In this case, without a specific duration
time, the effect will run until it is stopped or another event replaces it in the submaster.
Duration and cycles will be covered in the Advanced Effects chapter.
When changes have been made to an effect, *MOD* will be displayed in the Effects
select display to indicate that a store operation is necessary in order to save changes. If
a new effect is selected before storing, changes will be lost.
From Keypad
Use sets and sequences to create an effect:
Note: The default set is Set 0, which contains all patched channels as a single part. If
you plan to use Set 0, programming a set will not be necessary.
Step 1. Press [Effect] [n] [Set] [n] [Seq] [n] [Enter] to define a set and sequence for
Effect n. (Changes will be reflected in Effects Control display with “Effect”
highlighted.)
Step 2. Press [Store] [Effect] [n] to store changes.
EFFECTS
Bank 1 Page 1 Page 2 Page 3 Page 4 Page 5
1 2 3 4 5 6 7 8 9 10
Color2
cc>cn
VL7
Indicates that a store operation is necessary
*MOD*