Service manual

MAINTENANCE : MAINTENANCE PROCEDURES
2
02.9663.0010 D 23-Oct-02 27
Step 7. Re-install front cover.
Figure 2-9: Rotating Gobo Replacement/Cleaning
Front Cover
Rotating
Gobo
Lamp End
Rotate until open
end of carrier is up
Gear
Latch
Gobo Wheel
Open End
Closed End
Gobo MUST be oriented with side marked
"This Edge In" toward center of wheel and
side marked "Lamp Side" toward lamp. If
not oriented properly, gobo will break.
Be careful not to scratch gobo on side of
carrier when installing.
CAUTION:
Inside Edge
ThisEdgeIn
LampSide
Lamp Side (mirrored)
- orient toward luminaire lamp
(black side)
Center of Wheel
Gobo Positions
Gobo Wheel Front View
- orient toward center of wheel
Be careful not to pull metal spring clip carrier
back too far or it will not close properly.
CAUTION:
Sensor
open
1
2
3
4
5
6