Service manual

MAINTENANCE : MAINTENANCE PROCEDURES

02.9663.0010 D 23-Oct-02 25

Rear Head Assembly Removal

This procedure is necessary in order to access some components such as the gobo

wheel bulkhead and shutter assembly. Refer to as needed.

Tools:

#2 Phillips long handle screwdriver

To remove rear head assembly:

Step 1. Disconnect luminaire AC input cable from power source.

CAUTION: The rear head assembly is heavy and will remain attached by lamp wires.

Place luminaire on tech bench before removing rear assembly.

Step 2. At side rails, remove four 10-32x5/8" PPB screws and #10 split lock washers

(Figure 2-8). (Side rail spacers will come loose also.)

Step 3. Pull rear head assembly away from front head assembly.

Step 4. Re-install by doing steps 2 and 3 in reverse.

Figure 2-8: Rear Head Assembly Removal and Replacement

Rear Head Assembly

Front Head Assembly

10-32x5/8"

#10 Split

Lamp Wires

Yoke not shown for clarity.

NOTE:

Side Rail Spacer

PPB Screw

Lock Washer