User Manual

www.vareximaging.com 21
4343W X-ray Detector
REFERENCE MANUAL
8.11 Power-on and Power-off Sequence
To Power-on:
1 Insert the Battery into the 1 or 3-bay charger to remove from shut-down mode (only applies
to Batteries that are new).
2 Place Battery into X-ray Detector making sure the Battery latches into place, see Section 8.7.1
and Section 8.7.2. The X-ray Detector will automatically power-on when battery is inserted.
To Power-off:
1 Remove the battery from the X-ray Detector.
8.12 Reboot Sequence
The X-ray Detector may be rebooted if needed. To reboot:
1 Insert and remove the Battery 4 times within an 8 second window, see Figure 16.
Figure 16 Reboot Sequence
Note
When a Battery is inserted into the X-ray Detector, the LED Status Indicator
will turn orange as it boots. After booting, it connects to the configured
wireless router and is in Standby Mode, where the LED Status Indicator will
blink twice (2) per second. If the X-ray Detector does not connect to the
configured wireless router, it will blink slowly.
Note
Removal of the Battery does not automatically power-off the X-ray Detector.
The X-ray Detector will stay powered-on for approximately 3 minutes or
until discharged after battery removal.