User Manual
Table Of Contents
- 4343W X-ray Detector
- Table of Contents
- List of Tables
- List of Figures
- 1.0 Scope
- 2.0 Contraindication
- 3.0 Intended Use
- 4.0 Audience
- 5.0 Abbreviations
- 6.0 Definition of Symbols
- 7.0 Standards and Regulations
- 8.0 Description of the 4343W
- 8.1 Shipment Contents
- 8.2 Optional Parts
- 8.3 X-ray Detector Surfaces and Features
- 8.4 X-ray Detector Dimensions
- 8.5 X-ray Detector Specifications
- 8.6 Environmental Considerations
- 8.7 X-ray Detector Battery
- 8.8 Optional Varex Provided Inductive Battery Charger
- 8.9 Designing a Custom Inductive Battery Charger
- 8.10 Using a Third-Party Inductive Battery Charger
- 8.11 Power-on and Power-off Sequence
- 8.12 Reboot Sequence
- 8.13 LED Status Indicator Behavior
- 8.14 Position Sensing
- 8.15 Detector Sharing
- 9.0 The Detector Configuration File
- 10.0 System Software
- 11.0 Maintenance
- 12.0 Troubleshooting
- 13.0 Disposing of the X-ray Detector and Battery
- 14.0 Safety - Electromagnetic Interference
- 15.0 Regulatory
- Index
4343W X-ray Detector
20 www.vareximaging.com
REFERENCE MANUAL
8.10 Using a Third-Party Inductive Battery Charger
Any third-party Inductive Battery Charger meeting the Qi 1.2 standard at 15 watts may be used
for battery charging outside of the Bucky Tray. Refer to Figure 15 for the location of the inductive
charger receiver on the X-ray Detector for integrating a third-party Inductive Battery Charger.
Figure 15 Third-party Inductive Battery Charger and 4343W X-ray Detector Alignment
WARNING
Third-party Inductive Battery Chargers must not be used in the Bucky
Tray. Ignoring this warning may result in image artifacts or damage to
the X-ray Detector.
Caution
Third-party Inductive Battery Chargers do not support image
acquisition while using the charger.
Note
To support image acquisition while using the charger, the Varex
supplied Inductive Battery Charger or a custom designed Inductive
Battery Charger must be used, see Section 8.8 and Section 8.9.