Instruction manual

8215 L&J Tankway Communications Interface Module Tank Gate Interface
16 Installation and Operations Manual
Figure 3-1: L&J Tankway Tank Gate Interface Module
3.2.1 ID DIP Switch (SW1)
The dip switch is used for setting the ID number (1-14). The ID is a binary number representing
the address of the 8317 TGI.
Table 3-1: ID DIP Switch settings
Field wiring
terminal block (J3)
LED indicators (D1 – D6)
Surge/Shield
ground connector (J4)
External Power Connector
(+48 - 65 VDC) (J2)
+48-65 VDC power fuse
(1 A 250V TR5) (F1)
ID DIP Switch (SW1)
Transmit Line Fuse
(63 mA 250V TR5) (F2)
Firmware
Binary 8 4 2 1 Binary 8 4 2 1
Switch # 1 2 3 4 Switch # 1 2 3 4
Address 1 o o o c Address 8 c o o o
Address 2 o o c o Address 9 c o o c
Address 3 o o c c Address 10 c o c o
Address 4 o c o o Address 11 c o c c
Address 5 o c o c Address 12 c c o o
Address 6 o c c o Address 13 c c o c
Address 7 o c c c Address 14 c c c o
Address 1 Shown
CLOSED
OPEN
1234