Specifications

78
Reference Manual
00809-0100-2460, Rev AA
Section 6: Service and Troubleshooting
November 2014
Service and Troubleshooting
6.6 Replacing the Power Supply Unit
1. Disconnect the power supply.
2. Remove the two screws and open the lid on the 2460 housing. Note! The lid can be
removed from the housing if the lock ring is removed. Be careful not to drop the lid on
the floor.
3. Unplug the power connection.
4. Remove the two screws that keep the Power Supply Unit attached to the Main board.
5. Gently pull out the Power Supply Unit until the Main Board connector is accessible.
RX
POWER
LED BOARD
TX
Port 8b
Port 8a
Power connection
Lock Ring
RX
POWER
LED BOARD
TX
Port 8b
Port 8a
Power Supply Unit