Specifications

Reference Manual

00809-0100-2460, Rev AA

Section 5: Operation

November 2014

Operation

5.3.1 Start-Up Procedure

When the 2460 is starting up, the LEDs are lit up and turned off in a certain order to indicate

proper operation. In case an error is detected during the start-up procedure the red LED remains

turned on.

Start-up:

1. All LEDs are turned on

2. After 0.5 seconds the yellow (Status) LED is turned off.

3. When the start-up procedure is finished, the red (error) LED is turned off.

In case an error is detected during the start-up procedure, the error LED will start

blinking according to the appropriate error code as described in “Error LED” on

page 65.

4. The green (power) LED remains lit when the 2460 is powered on.