Instruction manual

8620 Driver Entry Terminal
Varec, Inc. 17
Variables Description Values Value Notes
HostInterfaceType Sets the Host Interface to either
Serial or Network
Network
Serial Default
TouchScreen Configures DET Software for
Touchscreen Interface (Currently
Touchscreen Not Supported)
TRUE
FALSE Default
Watchdog Enables Watchdog Feature
(Currently Not Supported DO NOT
Enable)
TRUE
FALSE Default
HostInterface Name If HostInterfaceType is set to
Serial, this parameter sets the
ComPort.
Com 1
Com 2
Com 3
Com 4
RS232
RS485/RS232
RS232
RS232
BaudRate Sets the Serial Baud Rate 4800
9600
19200
Default
Parity Sets the Serial Parity None
Even
Odd
Default
DataBits Sets the Serial Data Bits 8 Default
StopBits Sets the Serial Stop Bits one Default
Address Sets the Serial Address. If using
more than one DET on an RS-485
loop, then each must have a
unique address.
1
HostNetworkInterface Port If HostinterfaceType is set to
Network, this parameter sets the
Network Port.
4096
CardReaderSerial InterfaceEnabled This parameter enables or
disables the Card Reader.
TRUE
FALSE
Name If CardReadSerialInterface is
Enabled, this parameter sets the
ComPort.
Com 1
Com 3
Com 4
BaudRate Sets the Card Reader Baud Rate 4800
9600
19200 Default
Parity Sets the Card Reader Parity None
Odd
Even
Default
DataBits Sets the Card Reader Data Bits 8 Default
StopBits Sets the Card Reader Stop Bits 1 Default
Table 4-2: Variables Used in the DET.Config File