MSDS

ManualsBrandsVarathane ManualsKitchen3.75 oz. Red Mahogany Wood Putty (6-Pack)

C:\DOCUME~1\braunsha\LOCALS~1\Temp\notes6030C8\Wood Putties MSDS Prototype 12-2008.doc

02/10/09 1

Material Safety Data Sheet

24 Hour Assistance

1-847-367-7700

Rust-Oleum Corporation

www.rustoleum.com

Section 1 – Chemical Product / Company Information

Product Name Wood Putties - All Shades Revision Date December 1, 2008

Identification

Number

215200, 215203, 215204, 215193,

215194, 215195, 215196, 215297,

223177, 223178, 223179, 223250,

223251, 223252, 223253, 223254

Product Use/Class

Wood Putty/Varathane

Supplier Rust-Oleum Corporation

11 Hawthorn Parkway

Vernon Hills, IL 60061

USA

Manufacturer Rust-Oleum Corporation

11 Hawthorn Parkway

Vernon Hills, IL 60061

USA

Preparer

Regulatory Department

Section 2 – Composition / Information on Hazardous Ingredients

Chemical Name CAS Number Weight % Less

Than

ACGIH TLV-

TWA

ACGIH TLV-

STEL

OSHA PEL-

TWA

OSHA PEL-

CEILING

None

Section 3 – Hazards Identification

Route(s) of Entry:

Inhalation: Not acutely toxic by inhalation.

Skin: Non irritating if unbroken skin is contacted

Ingestion: Do not take internally. May cause gastrointestinal distress.

Eye Contact: May cause slight eye irritation. Avoid eye contact.

Section 4 – First Aid Measures

Emergency and First Aid procedures:

Inhalation: Remove patient to fresh air.

Skin contact: Wash affected area with soap and water.

Ingestion: Do not induce vomiting. Consult physician immediately.

Eye contact: Immediately flush eyes with water for 15 minutes. Consult physician if any irritation

persists.

Summary of content (4 pages)

PAGE 1
24 Hour Assistance 1-847-367-7700 Rust-Oleum Corporation www.rustoleum.
PAGE 2
Section 5 – Fire Fighting Measures Flash Point: >201 Noncombustible Flammable Limits: LEL: N.A. UEL: N.A. Extinguishing Media: Use extinguishing media appropriate for surrounding fire. Special fire fighting procedures: Remain upwind. Avoid breathing smoke. Unusual Fire/Explosion Hazards: Material can splatter above 100°C / 212°F. Section 6 – Accidental Release Measures Scoop up, place product into waste container for solid waste disposal. Section 7 – Handling And Storage Avoid eye contact.
PAGE 3
Section 10– Stability and Reactivity Stability: Stable Incompatibility (Materials to avoid): None known Hazardous Polymerization: Will not occur. Reactivity with common materials: Non reactive when product is used in accordance with intended use. Section 11 – Toxicological Information Product LD50: N.D. Product LC50: N.D. Section 12 – Ecological Information N.E. Section 13 – Disposal Information Disposal Information: Scoop up, place product into waste container for solid waste disposal.
PAGE 4
Section 16 – Other Information HMIS Health: 0 Flammability: 0 Abbreviations: N.A. – Not Applicable Physical Hazard: 0 N.D. – Not Determined N.E. – Not Established The information contained on this MSDS has been checked and should be accurate. However, it is the responsibility of the user to comply with all Federal, State and Local laws and regulations. C:\DOCUME~1\braunsha\LOCALS~1\Temp\notes6030C8\Wood Putties MSDS Prototype 12-2008.