Installation Guide

ManualsBrandsVaraluz ManualsBathroom LightingPolar 2-Light Blackened Silver Bath Vanity Light with Ice Crystal Glass

Electrical tape

Cinta aislante

WARNING: Review important safety instructions on second page

before installation. Check to make sure you have the following tools:

ADVERTENCIA: Revise las instrucciones importantes de seguridad en

la segunda página. Asegúrese que tiene las siguientes herramientas:

Item #182B02

Artículo #182B02

Required

Necesario

Flathead screwdriver

Destornillador plano

Phillips screwdriver

Destornillador de estrella

Helpful

Útil

Wire strippers

Pelacables

Pliers

Alicate

Wire cutters

Cortacables

Soft cloth

Tela de material suave

To Begin/Para Comenzar

2-Light Wall Fixture

Aplique de pared de 2 bombillas

Questions, problems, missing parts? Contact our Customer Care Center: 1-702-792-6900

Tiene preguntas, problemas, o faltan partes? Comuníquese con nuestro centro de Atención al Cliente: 1-702-792-6900

Page 1 of 4

Página 1 de 4

50-watt G9 halogen

lightbulb (2)

Bombillas tipo G9 de

50 vatios (2)

Safety glasses

Lentes de protección

Mounting screw (2)

Tornillo de montura (2)

Ground screw, green (1)

Tornillo a tierra, verde (1)

Mounting plate (1)

Placa de ﬁjación (1)

Included Hardware

Partes incluidas

Wire nut (2)

Cono aislante para

empalmes (2)

Summary of content (4 pages)

PAGE 1
Item #182B02 Artículo #182B02 2-Light Wall Fixture Aplique de pared de 2 bombillas To Begin/Para Comenzar WARNING: Review important safety instructions on second page before installation. Check to make sure you have the following tools: Required Necesario Helpful Útil ADVERTENCIA: Revise las instrucciones importantes de seguridad en la segunda página.
PAGE 2
Safety Instructions Instrucciones de seguridad WARNING: FOR YOUR PROTECTION AND SAFETY - Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could lead to electric shock, fire or other injuries which could be hazardous or even fatal. 1. All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
PAGE 3
Preparation/Preparación Reminder: Read the safety instructions on page 2 of this manual before installing this fixture. 1. Advertencia: Shut off main power at the circuit breaker or fuse panel before removing old fixture. 2. Quite el artefacto viejo. Desconecte los cables viejos. Corte la electricidad en la caja principal de fusibles (o la caja del interruptor automático) antes de quitar el artefacto viejo.
PAGE 4
5. Install light bulbs. Use only 50 watt G9 halogen bulbs. Make sure to wear gloves when installing halogen bulbs. 6. Install glass panels. Secure each panel with the two screws provided at each panel location. Make sure to not overtighten the screws. Doing so may crack the glass. Instale las bombillas. Use solamente bombillas halógenas tipo G9 de 50 vatios. Asegúrese de usar guantes al instalar las bombillas. Instale los paneles de vidrio.