ASSEMBLY DIAGRAM PARTS LIST PARTS LIST PARTS LIST HARDWARE LIST NC| DESCRIPTION QTY DESCRIPTION [QTY] |NO| DESCRIPTION QTY|NO| DESCRIPTION [QTY] z= S : Bottom middle Three—in—one, Left side I 24%20mm 1 drawer bo 2 A |eccentric fou panel scree wheel Right side panel 1 lower Three-in-one Dor drawer homecoming 5 |£1| H | pane 7 1 panel rod Lower 5 Boston Three-in-one Drover panel 1 drover wae |sticker handle Middle © middle side .
STEP 1 HARDWARE LIST Three—in—one connecting rod 2 B « PCS 1.Put the connecting rod in the 10mm hole of the following panels and tighten them with a cross screwdriver or an electric tool. STEP 2 1.Strike the 08%40mm wood dowel pin into the 8m hole of the above panels with an iron hammer. Please note that the hole of the connecting rod should also be 8mm. The hole of the connecting rod connects to the hole of 15mm three-in-one eccentric wheel.
STEP 3 Drawer slides snap switch HARDWARE LIST Drawer slides E ~~ PCS & L.Press the slide snap switch, disassemble slide blocks and put them in a place properly for further use. L Fix the drawer slide to the side panel with 4%16mm screws.
1.Connect No. 3-5-7-8 panel to No.2 panel tightly with the eccentric wheel. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one eccentric wheel | sticker A fg 11PCS | C () 11PCS 2 1.Connect No. 1 panel to No. 3-6-T-panel tightly with the three-in-one eccentric wheel. 2.
STEP 7 L Fix feet of the cabinet with 4*16mm screws. HARDWARE LIST 4%16mm screw Aluminum alloy leg 2 F * PCS | J PCS L Install No. 16-17-18-19 panels with the three-in-one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker.
1.Install No. 10-11-12-13-14-15 panels with the three-in-one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker.
STEP 10 l.Lock the spare drawer slide block to the drawer. 2.Install the drawer handle with 4#20 handle screws. HARDWARE LIST 4Ax16mm screw Drawer slides Fo PCS | 2 4%20mm scr on Drawer handle 1 2 arcs 1.Align slide block with the trough on the guide rail, press the snap switch and press it forward to install the drawer. 2.Install drawer handles.
1.Install the hinge cup to the door panel with 4¥16mn screws. 0 2.Install the hinge to the side panel with 4%16mm screws. 4.Adjust the door panel clearance. 3.Install the hinge HARDWARE LIST cup on the door 4%16mn screw Door hinge panel to the hinge 2 F @* PCS | K 358, PCS of the side panel. 9 L.Install the door handle with manhandle screws.
Choking hazard-Small Parts : This unit contains small parts, not for children under 3 years. Tip-over hazard : Secure finished unit to wall stud using L-Bracket and wall screw provided). If a wall stud is not accessible, Consult your local hardware store for appropriate mounting hardware . Failure to properly install will result in product collapse or tip-over. Serious injury can occur .