ASSEMBLY DIAGRAM PARTS LIST PARTS LIST PARTS LIST HARDWARE LIST NO | DESCRIPTION [QTY|N = DESCRIPTION [TY] [NO| DESCRIPTION [QTY|NO| DESCRIPTION [QTY i 5 Three-in-one, i Left side Right door none 2 Aluminum panel 0 1 panel J 1 A concentric tx 26 |G alloy leg if 4 whee Three-in-one drawer left 2%16mm panel homecoming sever of |48 Right side panel 1 rod Boston right side Three-in-one 442m panel 1 of drawer |sticker setscrew Pl 6 Tear drop drawer back] 8%40m wood Door down = 1 panel dowel pins 14] J dandle 2 L
STEP 1 HARDWARE LIST Three—in—one connecting rod gr B « PCS 1.Put the connecting rod in the 10mm hole of the following panels and tighten them with a cross screwdriver or an electric tool. STEP 2 A 1.Strike the 8%40mm wood dowel pin into the 8mm hole of the above panels with an iron hammer. Please note that the hole of the wood dowel pins should also be 8mm. The hole of the three-in-one connecting rod connects to the hole of 15mm eccentric wheel.
STEP 3 >" Drawer slides snap switch STEP 4 L Fix the drawer slide to the side panel with 4%16mm screws. HARDWARE LIST Drawer slides E ~~ PCS { L.Press the slide snap switch, disassemble slide blocks and put them in a place properly for further use.
1.Connect No. 3-4-5-6-7 panel to No.2 panel tightly with the eccentric wheel. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker. HARDWARE LIST Three-in-one eccentric wheel A PCS sticker Cc (O PCs EE 1.Connect No. 1 panel to No. 3-4-5-6-7 panel tightly with the eccentric wheel. 2.
L Fix feet of the cabinet with 4*16mm screws. HARDWARE LIST 4%16mm screw Aluminum alloy leg Ho 125CS | G FF apes a L Install No. 10-11-12-13-14 panels with the three-in-one eccentric wheel tightly. 2.Cover the mounting hole of the eccentric wheel with a three-in-one sticker.
l.Lock the spare drawer slide block to the drawer. 2.Install the drawer handle with 4#23 handle screws. HARDWARE LIST 4%16nm screw Drawer slides Ho PCS 2 4%23mm screw Drawer handle I ¢® PCS | Ke 2 PCS 1.Align slide block with the trough on the guide rail, press the snap switch and press it forward to install the drawer. 2.Install drawer handles.
STEP 11 1.Install the hinge cup to the door panel with 4¥16mn screws. 2.Install the hinge to the side panel with 4%16mm Screws. 4.Adjust the door panel clearance. 3.Install the hinge HARDWARE LIST cup on the door 4%16mn screw panel to the hinge of the side panel. Ho PCS Door hinge F 28, PCS = l.Install the door handle with manhandle screws.
Choking hazard-Small Parts : This unit contains small parts, not for children under 3 years. Tip-over hazard : Secure finished unit to wall stud using L-Bracket and wall screw provided). If a wall stud is not accessible, Consult your local hardware store for appropriate mounting hardware . Failure to properly install will result in product collapse or tip-over. Serious injury can occur .
