User Manual

Critical event detection is triggered by the G-Sensor (Gravity

Sensor) and will auto-detect vehicle impacts and collisions. This

will cause the camera to protect the current video clip from

being overwritten by locking it and saving the footage in the

“Video/Event” folder.

The vehicle driver can also manually lock the current video

recording session by pressing the OK Button. A key icon will

appear at the center of the screen.

The vehicle driver can also manually lock the current video

recording session by pressing the OK Button. A key icon will

appear at the center of the screen.

The G-Sensor sensitivity is adjustable with 3 settings: Low,

Medium, and High – it is set to Medium

by default. The G-Sensor can also be

deactivated in “Record Setup”►“G-Sen-

sor Set”.

Event videos are stored in the

“Video/Event” folder, and cannot be

automatically overwritten.

Note: The camera will auto overwrite old

Event videos once the Event folder has

accumulated 30% of the card capacity.

Please regularly transfer important

videos to your PC or another storage

location (e.g.external hard drive). To

maintain good read/ write performance,

the microSD card should be formatted

every 1-2 two weeks.

Setup”►“Loop Recording” to change it

- 14 -

4.5

Event Recording

cam recorded files . Standard files are stored in the “Video/Nor-

mal” folder. When the Micro SD card is full, the camera will write

over older files.

When Loop Recording is turned off, the camera will record video

in 15

minute clips, but will not overwrite old videos when the

storage card is full.

00:00:16

000MPH

14:42:252019/04/10

0.0

1920x1080P 30FPS

HDR

OnDash S1