VT-TAB07-RK68H User Manual VT-TAB07-RK68H Hardware User Manual Product Version: 2.0 Date: 2020-10-15 For any question, please contact Chengdu Vantron Technology, Ltd. Copyright © Vantron Technology, Ltd. All rights reserved.
Change History This table describes the version and release date. Rev. Date Description Author 1.0 2020-01-17 Initial Version YC 2.
Foreword Copyright While all information contained herein have been carefully checked to assure its accuracy in technical details and printing, Vantron assumes no responsibility resulting from any error or features of this manual, or from improper uses of this manual or the software. Please contact our technical department for relevant operation solutions if there is any problem that cannot be solved according to this manual.
Limitation of Liability/Non-warranty For direct or indirect damage to this device or other devices of Vantron caused by failure of conforming to this manual or the safety instructions on device label, Vantron assumes neither warranty nor legal liability even if the device is still under warranty. The device should be installed, debugged and maintained by professionals. The outside antennas are not permitted to be installed or to be changed by non-professionals.
Safety Instructions for Power Cables and Accessories Use Proper power source only. Start only with power source that satisfies voltage label and the voltage necessary according to this manual. Please contact technical support personnel of Vantron for any uncertainty about the requirements of necessary power source. Use tested power source.
Contents 1 2 3 4 5 INTRODUCTION ................................................................................................................................................ 1 1.1 PRODUCT DESCRIPTION .................................................................................................................................................... 1 1.2 CONNECTOR DESCRIPTION ...........................................................................................................................
1 1.1 Introduction Product Description Vantron offers both ARM and ATOM based Single Boards Computer (SBC) platforms including Cirrus LogicEP9315, RockChip RK3128, RK3368, RK3288, RK3399, Freescale iMX6, iMX8, TI OMAP35xx CortexA8 series, and Intel Skylake and ApolloLake processor boards. In additional to offering the standard SBCs, we also provide professional customization board design services.
3.3V 3.3V signal level 5V 5V signal level USB 5V tolerant signal PCIe PCI Express signal, not 3.
2 2.1 Overview Introduction VT-TAB07-RK68H is a tablet computer designed for entertainment application. This product is based on RK3368Hwhich has Octacores and one of them is Cortex-A53with a maximum clock frequency of 1.5GHz, supporting10.1" LCD and capacity touch screen. 2.2 Feature Specifications CPU Memory Processor RK3368H, CPU:Octa-core Cortex-A53,up to 1.5GHz GPU:G6100,up to 600MHz RAM 1GB LPDDR3 Flash EEPROM 8GB eMMC 2Kb Real-time video decoder, MPEG-2, MPEG-4,H.264,VP8 H.
Audio RTC Speaker 1 x 1.0W speaker at lower left Headphone 1 x 3.5 mm Headphone jack with MIC input, on the top MIC 1 x MIC on the top RTC Supported OS Android 10 Applications Provide SDK DC Input USB TYPE-C supports 5V/2A DC power supply. (Recommended: 5V/2A) Battery 3.
3 3.1 Hardware Instructions Appearance Figure 3-1 Views 3.2 Interface Description Figure 3-2 Interfaces MIC USB TYPE-C 3.5mm Headphone jack 3.3 Structure Download the board structure document from Vantron technology or Vantron net site: www.vantrontech.com.
Figure 3-3 Structure Unit: mm 6
4 Hardware Function Description This chapter mainly describes the main hardware functions of this product, including 4G, WIFI/BT, audio, display,and charging. 4.1 WIFI/BT The wireless module inside the tablet complies with IEEE 802.11 a/b/g/n/ac standard and it can achieve up to a speed of 433.3Mbps with single stream in 802.11ac draft to connect to the wireless LAN. The integrated module provides SDIO interface for Wi-Fi, and UART interface for Bluetooth. Features: ● IEEE 802.
4.3 Display VT-TAB07-RK68H has a 7.0" screen. The screen is made up of a display screen and a touch screen, which are fitted together by full-fit technology. More parameters are shown in the table. Item Specifications Unit Screen Size 7.0" Inch Viewing direction Full View - Resolution 1024x600 - Display Mode Normally Black - Number of Colors 16.7M - LCM Luminance 280 (Typ.) cd/m2 Contrast Ratio 700:1 - Interface LCDS - Touch Screen Cap-touch, 5-point 4.
5 Hardware Operation Note This chapter provides a guide to set up and use some of the features of the tablet. For more details, see hardware description. 5.1 Power Preparation 5.1.1 Environment Before the equipment is powered on, please confirm whether the environmental conditions meet the requirements. Environmental conditions are as follows: ● Operation Temperature: 0°C ~ +45°C ● Operation Humidity: 10-85%RH (Non-Condensation) 5.1.
6 Software Instructions VT-TAB07-RK68H has been pre-loaded firmware. For more information, please refer to software user manual for software operation.
7 Tips Waste Disposal It is recommended to disassemble the device before abandoning it in conformity with local regulations. Please ensure that the abandoned batteries are disposed according to local regulations on waste disposal. Do not throw batteries into fire (explosive) or put in common waste canister. Products or product packages with the sign of “explosive” should not be disposed like household waste but delivered to specialized electrical＆electronic waste recycling/disposal center.
Notice Considering that reasonable efforts have been made to assure accuracy of this manual, Vantron assumes no responsibility of possible missing contents and information, errors in contents, citations, examples, and source programs. Vantron reserves the right to make necessary changes to this manual without prior notice. No part of this manual may be reprinted or publicly released in forms of photocopy, tape, broadcast, e-document, etc.
Appendix A: How to Contact Us If you have any problem or want to know more about our products, visit www.vantrontech.comor contact us. US Office: Vantron Technology, Inc. Address: 440 Boulder Court, Suite 300, Pleasanton, CA 94566, USA Tel: 925-621-8758 Email: sales@vantrontech.com China Office: Chengdu Vantron Technology, Ltd Address: 6th Floor, 1stBuilding, No.9, 3rd Wu KeEast Street, Wu Hou District, Chengdu 610045, China Tel: 86-28-8512-3930/3931, 8515-7572/6320 Email: sales@vantrontech.com.
