User Manual

UCTTA-42 User’s Manual
-13- www.vantrontech.com.cn
This status is power off.
4.1.2 AC Jack
This port plug in a AC100V~240V cable.
Notice：Only one of the two power connectors can be connected. After one of the
power connectors is powered on, the other connector is powered on, so Please do not open
the lid.
Warning：Avertissement：
□ Installation Statement: AC INLET is not accessible during normal use.
□ Déclaration d’installation : AC INLET n’est pas accessible en cas d’utilisation
normale.
□ Installed by a professional, it is fixed after installation, and the AC inlet is wrapped inside the
corner of the installation table.
□ Installé par un professionnel, il est fixé après l’installation et l’entrée CA est enveloppée dans
le coin de la table d’installation.
4.1.3 Recovery button ( Internal )
This button function is for update. While push the recovery button and power on the
display plane, it will work at recovery mode. At this time, user can update the display plane
with a micro USB-B cable.
4.1.4 Debug interface ( Internal )
The debug interface is reserved for UCTTA-42 display the debug information and
communicate with PC, use the debug cable.