Installation Manual

JOINING YOUR SHOWER PANEL
1.Open the box and take out the shower panel .
Make a visual inspection to ensure there is no breach or defect.Familiar with the
system for water connection located at the back of the shower panel.
2.Connect hand shower to shower panel with flexible hose.
Pay special attention to each end of the hose.One end is connected to bolt on the
shower panel and the other to the hand shower.Make sure there is a rubber
sealing ring before connecting each of them.
3.Install the rain shower pole to the head of shower panel.
It's better to install the pole first without rainfall shower head to make a better fit
with nut located on the rear of shower panel,and then the shower head.
DO NOT TIGHTEN THE NUT TOO STRONG TO THE SHOWER ARM