Installation Manual

NOTE:(3 critical steps to ensure your shower panel function properly)
(1 make sure the cold water connet to cold water input end of control valve with a BLUE TAB and
the hot water to the hot water input end with RED TAB.
(2 do not drop the back flow fiters on both ends of control valve when you take the TAB.
Attention this shower panel is designed for flat wall mounting.
(3 rinse out of all remaining debris and dirt in the house water supply system or the cartridge
inside the thermostat valve will be damaged easily.
input
hot
water
input
cold
water
Preparation for installation
The tools for installing a shower
panel includes the those on the
right one person and an assistant
are recommended for an easy
installation.
Silicon is necessary for installing
this shower panel,however you
may glue the panel on the wall
with silicon.