Installation Manual

THANK YOU FOR CHOOSING OUR SHOWER PANEL
Please take few minutes to read the manual before you begin installation. Our shower
panel is made for a quick and simple installation. We strongly recommend you to ask
thecertified plumber to install the shower panel . However, if you encounter a problem
after a proper installation, do not hesitate to contact your certified dealer.
ALWAYS OBEY THE PLUMBING CODE AS THE BUILDING CODE IN FORCE.
For your protection please always wear safety glasses. Following the instructions which
indicate you the steps to install your new shower panel. Your current installation may
require changes in old one, please make sure you have enough area to install it.
The installation of your shower panel is determined by the ideal height for you and your
family.
Cut the existing plumbing pipe if its necessary. The plumbing connectors (COMP 1/2''×
1/2''MIP) are ready to be installed in the most current system. However, if your current
system does not allow to connect to your new shower panel, you may have to open the
wall to change your old system.
Once you remove your old shower panel and are ready to install your new shower panel,
it should cover the wide space occupied by your old shower panel. Please take the time
to read each step before starting installation, make sure all the tools necessary for the
proper conduct of installation are in hand. Before installation, please inspect your shower
panel to make sure that there is no damage. If you find any abnormality, please
immediately return the product with its original packaging to your licensed dealer. Please
leave your product in its original package until you are ready for the installation.
We recommends providing the cold (B) and hot (A) water outlets in one of positiongs
indicated with the symbol (Φ Φ), with outle pipes of 14 mm. Next to the wall,two fi "
male-male connectors will be installed, followed by two 1/2"elbows with female
connection (connector side) and male connection ( flexible pipe side).
The mininum pressure in the water circuit of the flow enclosure must be 3 bars/300 kPa
The mininum pressure in the water circuit of the flow must be 5 bars/500 kPa
Attention!The feeding pipes have to be rinsed thoroughly before the installation of the
mixer,so that no shavings,welding or hemp residual or other dirt can be found in the pipes