manual

v 1.01
www.vantecusa.com
Model: MRK-320ST-CK / MRK-320ST-BK*C
MRK-320ST-BK Front View
MRK-320ST-BK Rear View
MRK-320ST-BK*C Front View
MRK-320ST-BK*C Front View(Handle Up)
LED Indicators
Power LED:
Keylock - LOCK position - Solid Green LED
Keylock - Open position - NO LED
Disk Activity LED:
Disk Activity - Blinking Orange LED
No Disk Activity - NO LED
KEYLOCK (Switch)
Keylock is for securing the Carrier Tray to the Unit AND for
turning POWER ON/OFF to the Drive.
POWER/SATA DATA Connectors
* Use either P01 or P02 will provide power to the drive.
DO NOT USE BOTH !
** You can use SATA or SAS drive in this storage unit, but
SATA drives HAVE to be connected to SATA controller
and SAS drive HAVE to be connected to SAS controller.
SAS drive support Primary Channel.
P02
D01
P01
P01: SATA Power Port*
P02: 4-Pin Molex Power port*
D01: SATA DATA Connector**
HDD Activity Switch
NOTE : Some hard drive(s) not using SATA datas signal for
disk activity may cause the Disk Activity LED to be OFF.
ON: Show Disk Activity
OFF: NO LED
FAN Replacement steps on
Carrier Tray
1. Lift handle bar to show screws.
2. Remove two screws holding fan cover plate.
3. Remove fan cover plate and remove two screws
holding FAN.
4. Unplug to disconnect the Fan connector to remove
the Fan