Installation manual

www.fmiproducts.com
113195-01N 17
INSTALLATION
Continued
Figure 24 - Installing Log Set (Top View)
Figure 25 - Installing Screen
Notches
Screws for
Mounting
Screen
Burner
Ports
Figure 23 - Installing Log Set
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Chassis
Log
Set
Crossover
Log #3
Burner
Front
Log #2
Back
Log #1
Grate
Prongs
INSTALLING LOGS
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty and safety
information.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
WARNING: After installa-
tion and periodically thereafter,
check to ensure that no ame
comes in contact with any log.
With the heater set to HI, check
to see if ames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place back log #1 on grate to t as il-
lustrated in Figure 23. Make sure middle
section at bottom of log set is seated into
“U”-shaped cutout in center of chassis
(see Figure 23). IMPORTANT: Make sure
log does not cover any burner ports (see
Figure 24).
2. Place front log #2 against front grate
prongs as shown in Figure 23.
3. Place crossover log #3 on top of front and
back logs as shown in Figure 23.
4. Place lava rock around base of heater if
desired.
WARNING: You must oper-
ate this replace insert with the
replace insert screen in place.
Make sure replace insert screen
is in place before running re-
place insert.