Installation manual

www.fmiproducts.com
123502-01E22


Note: All remote control accessories must
be purchased separately (see Accessories,
page 36). Follow instructions included with
the remote control.

-
Lighting
Instructions
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust ame adjustment knob anywhere
between HI and LO. Slide the selector switch
to the REMOTE position (see Figure 32).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Figure 32 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Flame
Adjustment Knob
Control
Knob
Selector Switch in Remote
Position (Optional Remote Control)
OPERATION Continued
REMOTE-READY MODELS

MOUNTED THERMOSTAT
Set the temperature adjustment on wall ther-
mostat to the desired setting. The thermostat
has been electronically calibrated at the fac-
tory and requires no adjustment or leveling.
Upon installation, the thermostat must be
allowed to stabilize at room temperature for
a minimum of 30 minutes for proper opera-
tion. See installation instructions on pages
16 and 17.

MOUNTED SWITCH
This wall switch works just like the conven-
tional light switch. Flip switch up for on and
down for off.
Note: Make sure that this switch is not in a posi-
tion to be mistaken for a light switch. This may
result in the replace being inadvertently turned
on without the proper precautions being taken.
See installation instructions on page 17.