Installation manual

www.fmiproducts.com
123502-01E16

REMOTE CONTROL ACCESSORIES



1. Disconnect jumper wires from the control
valve (see Figure 19).
2. Locate the battery cover on the back of
the receiver (see Figure 20).
3. Install 4-AA batteries (included) into re-
ceiver before installing into replace.
4. Connect wires from remote receiver to
control valve. See instructions provided
with remote control kit for further informa-
tion.
INSTALLATION
Continued
Figure 19 - Disconnecting Jumper Wires
From Control Valve
Figure 20 - Attaching Batteries to
Receiver



WARNING: Read and fol-
  
Installation should be done by


WARNING: Do not connect
this thermostat to any electrical


1. Remove jumper wire from control valve
(see Figure 19).
2. Connect one terminal of 25 ft. wire to
the “TH” terminal on the control valve.
Connect the other terminal to the “THTP”
terminal on the control valve. See Figure
21, page 17.
3. Route the 25 ft. wire to a convenient loca-
tion to mount your thermostat (no outside
wall). IMPORTANT: The wire may be
shortened but must not be lengthened.
The thermostat should be mounted 54"
above the oor in a location where there
is good air circulation. Avoid heat sources
such as lamps, direct sunlight, replace
or heat and air conditioning ducts.
4. Gently remove cover of thermostat from
base. Grasp sides of cover rmly and pull
to separate from base.
5.
Feed electrical wires through rectangular
slots on each side of base (see Figure 22).
REMOTE
NO
FFO
LEARN
ADJ.
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Frequency
adjusting
access hole
Remote Receiver
Battery cover slides on/off
Slide
Switch
ON
REMOTE
OFF